TM 1-4920-446-13 & P
Table 3-1. Daily Inspection Requirements
Control panel gauges and controls
Check fluid level; add fluid as needed.
Inspect for leaks. Check hydraulic line
connections for loose connections and
damage. Correct or report defects.
Check electrical wiring for breaks,
worn insulation, and loose connec-
tions. Correct or report defects.
Inspect tires for deep cuts and exces-
sive wear. Correct or report defects.
Check for broken glass, bent indicat-
ing needles, or other obvious defects.
Check that all controls operate
smoothly and are tightly mounted.
Correct or report defects.
Start and operate test stand and check
for hydraulic leaks. Check to make
sure that 3000 PSI hydraulic pressure
can be obtained at maximum GPM
flow. Check temperature and flow in-