ASSEMBLY - Continued
Do not work under vehicle unless hull is on jack stands and apron lockpins are installed.
Failure to comply may result in severe injury or death to personnel.
· Installation steps are accomplished through access under vehicle.
· After installation is complete, remove tags from all hydraulic lines and wiring harness
Install aft manifold (Figure 4, Item 6) in vehicle with three new hexagon head cap screws (Figure 4, Item 4)
and three flat washers (Figure 4, Item 5).
Remove caps from adapters and plugs from hydraulic hose connector ends and connect six hydraulic hoses
(Figure 4, Item 3) to aft manifold (Figure 4, Item 6).
Connect wiring harness W3 connectors P4, P6, P7, P8, and P18 (Figure 4, Item 1) to five two-way valves
V4, V6, V7, V8, and V18 (Figure 4, Item 2) on aft manifold (Figure 4, Item 6).
Remove tags from all hydraulic hoses and wiring harness W3 connectors.