Quantcast Chapter 3. MAINTENANCE INSTRUCTIONS

 

Click here to make tpub.com your Home Page

Page Title: Chapter 3. MAINTENANCE INSTRUCTIONS
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Figure 2. Ram and Reservoir Assembly.
Up
TM-55-1730-213-12 Jack Hydraulic Tripod 12-Ton Fixed-Height Part No. 1214-151 Manual
Next
Section III. LUBRICATION.
TM 55-1730-213-12
AV 006463
Figure 3. Complete Jack Assembly.
Section III. OPERATION UNDER UNUSUAL CONDITIONS
14. OPERATION IN DUSTY OR SANDY AREAS.
b. To minimize moisture contamination of the
hydraulic fluid, open the air vent only when required for
a. Lubricate the jack in accordance with lubrication
operation.
instructions contained in paragraph 23.  Keep lubricant
containers clean and covered to prevent contamination.
16. OPERATION IN SALT WATER AREAS.
b. Protect the jack from dust and sand as much as
possible.  Clean jack frequently and cover jack with
tarpaulin when not in use.
a. Protect all exposed metal surfaces from the
corrosive action of salt air with a thin film of oil.
15. OPERATION UNDER HUMID CONDITIONS.
b. Retouch or repaint the jack as required to protect
a. Clean all exposed areas frequently and apply a
painted areas from corrosion.
thin film of oil to all exposed metal surfaces.
CHAPTER 3
MAINTENANCE INSTRUCTIONS
Section I. SERVICE UPON RECEIPT OF EQUIPMENT
17. UNCRATING EQUIPMENT
18. INSPECTION OF NEW EQUIPMENT.
a. Perform the before-operation services described
CAUTION
Exercise care in removal of the crate top to
prevent damaging the equipment with the
b. Make a thorough visual inspection of the
prying tool.
equipment for cracks, breaks, distortion, and loose or
missing parts.
a. Pry the top from the crate's sides and remove the
jack and allied parts from the crate.
c. Inspect all parts and assemblies for correct and
secure mountings.
b. Remove the pressure-sensitive tape from all
sealed openings.
Remove preservatives from all
unpainted metal surfaces with cleaning solvent (Federal
Specification P-D-680).
5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.
6230 Stone Rd, Unit Q Port Richey, FL 34668

Phone For Parts Inquiries: (727) 493-0744
Google +