INSTALLATION - LOW PRESSURE GAGE

TM 55-4920-442-13 & P

3-94.

Instruments - Replace (cont)

3-94

INSTALLATION - LOW PRESSURE GAGE

1. Install gage through front of panel and attach with three mounting screws.

2. Connect gage at test port tee on back of panel.

3. Install gage cover and tighten thumb screw.

INSTALLATION HIGH PRESSURE GAGE

1. Install gage through front of panel and attach with three screws and washers.

2. Connect flexible hoses to gage in back of panel.

3. Install cover and tighten thumb screw.

INSTALLATION FILL PRESSURE GAGE

1. Install gage through front of panel and attach with three screws and washers.

2. Connect flexible hoses to gages in back of panel.

INSTALLATION OIL TEMPERATURE GAGE

1. Install gage through front of panel and attach with three screws and washers.

2. Route line from the oil temperature gage over the cooler fan shroud to the low pressure filter manifold (under the

low pressure filter). Fasten line in place with cable clamps.

GO TO NEXT PAGE

3-145