|
| |
TM 1-4920-446-13 & P
3-88 Instruments - Replace (AVIM) (Contd)
3-88
Removal: Low pressure and high pressure indicator lamps (18) and (19)
1.
Remove three electrical wires.
2.
Remove bezel.
3.
Remove attaching nut.
4.
Remove indicator lamp from rear of panel.
Installation: Fluid temperature gauge (4)
1.
Install gauge through front of panel and attach using mounting hardware.
2.
Connect line at low pressure filter manifold (under the low pressure filter), then secure to chassis using routine
clamps.
Installation: Fuel gauge (5)
1.
Insert gauge through front of panel and attach using mounting hardware.
2.
Connect wires to gauge.
Installation: Hourmeter (1)
1.
Insert meter through front of panel and attach using mounting hardware.
2.
Connect wiring at back of meter.
Installation: Flowmeter (17)
1.
Insert indicator through front of panel and attach using mounting hardware.
2.
Connect wire at back of indicator.
Installation: Low pressure and high pressure indicator lamps (18) and (19)
1.
Install indicator lamp from rear of panel.
2.
Install attaching nut.
3.
Install bezel.
4.
Install three electrical wires.
END OF TASK
3-116
|
