|
| |
TM 1-4920-446-13 & P
3-22.
Axles and steering assembly - Replace (Contd)
3-22
3.
Install two small jacks under front axle.
4.
Remove cotter pins from bolts connecting axle to the spring.
5.
Remove nuts and bolts connecting the axle to the spring.
6.
While supporting forward radius rod, disconnect two radius rod clamps.
7.
Lower the axle with the small jacks.
8.
Remove small jacks.
9.
Pull the front axle out of the front of the test stand.
INSTALLATION:
Front Axle and steering assembly.
1.
Position front axle and steering assembly below elevated test stand.
2.
Place two small jacks under axle.
3.
Support radius rod then raise axle and attach to spring assembly with nuts and bolts.
4.
Install cotter pins in spring bolts.
5.
Attach radius rod using radius rod clamps.
6.
Remove the two small jacks.
7.
If only replacing front axle and steering assembly, lower test stand to ground and remove jack stands.
GO TO NEXT PAGE
3-22
|
