|
| |
TM 1-4920-446-13 & P
3-37.
Brake assembly - Inspect (Contd)
3-37
6.
Remove cotter pin from hex nut.
7.
Remove nut and washer.
8.
Remove wheel assembly.
9.
Check brake drum and shoe for wear.
10.
Check brake drum and shoe assembly for evidence of grease, oil or other contaminants.
11. Check brake assembly for loose, missing or damaged parts.
REASSEMBLY FOLLOWING INSPECTION
1.
Install wheel, drum and bearing as a unit.
2.
Install outer bearing.
3.
Install washer and hex nut.
4.
Tighten hex nut while turning wheel until resistance is felt. Back off 1/8 turn to nearest cotter pin slot.
5.
Install cotter pin and bend open end of cotter pin.
6.
Install grease cap.
7.
Remove jack stands.
8.
Lower unit to the ground.
END OF TASK
3-43
|
