|
| |
TM 9-5130-338-12&P
a.
Disassembly.
1.
Remove snapring (1) from main shaft (2). Discard snapring.
2.
Position hydraulic impact wrench so that motor cap (3) is facing upward.
3.
Remove eight capscrews (4), eight lockwashers (5), and motor cap (3) from main housing (6). Discard
lockwashers.
NOTE
Dowel pin (7) may adhere to either main housing (6) or motor cap (3).
4.
Remove two preformed packings (8 and 9) and dowel pin (7) from motor cap (3). Discard preformed
packings.
5.
Remove main shaft (2), idler gear (10), and idler shaft (11) from main housing (6).
6.
Remove backup washer (12), flat preformed packing (13), and round preformed packing (14) from main
housing (6). Discard preformed packings.
7.
Remove bushing (15) from main housing (6). Remove two bushings (16 and 17) from motor cap (3).
b.
Inspection.
Inspect motor assembly in accordance with paragraph 4-19.
4-17
|
