|
| |
TM 9-5130-338-12&P
4-19. INSPECTION-ACCEPTANCE/REJECTION CRITERIA-Continued.
WARNING
Dry-cleaning solvent (P-D-680) is toxic and flammable. Wear protective goggles and gloves; use
only in well-ventilated area; avoid contact with skin, eyes, and clothes, and do not breathe
vapors. Keep away from heat or flame. Never smoke when using solvent; the flashpoint for type
I dry-cleaning solvent is 100°F (37.8°C) and for type II is 138°F (58.9°C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and medical
help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts eyes,
immediately flush eyes with water and get immediate medical attention.
(2)
Thoroughly clean gear shaft (6) and gear (3) with dry-cleaning solvent (Appx. C, item 16) to
remove any particles of dirt, sand, grit, etc., prior to installation. Dry with cloth (Appx. C, item
5).
(d)
Component parts. Inspect remaining parts of motor unit as described in beginning of this
section.
4-22
|
