|
| |
TM9-6115-667-13&P
HYDRAULIC HOSE REQUIREMENTS
HOSE TYPES
Hydraulic hose types authorized for use with this unit are as follows:
(1)
Certified non-conductive
(2)
Wire-braided (conductive)
(3)
Fabric-braided (not certified or labeled non-conductive)
Hose (1) listed above is the only hose authorized for use near electrical conductors.
Hoses (2) and (3) listed above are conductive and must never be used near electrical conductors.
To help ensure your safety, the following DANGER tags are attached to all hose exceeding 6 feet in length purchased from
Stanley Hydraulic Tools. DO NOT REMOVE THESE TAGS.
If the information on a tag is illegible because of wear or damage, replace the tag immediately. A new tag may be
obtained at no charge from the manufacturer or any dealer.
(1) CERTIFIED NON-CONDUCTIVE HOSE
This tag is attached to all certified non-conductive hose.
SIDE 1
(shown smaller then actual size)
SIDE 2
(2) AND (3) WIRE-BRAIDED AND FABRIC-BRAIDED (NOT CERTIFIED OR LABELED NON-CONDUCTIVE) HOSE
This tag is attached to all conductive hose.
SIDE 1
(shown smaller then actual size)
SIDE 2
HOSE PRESSURE RATING
The rated working pressure of the hydraulic hose must be equal or higher than the relief valve setting on the hydraulic
system used to power the hydraulic motor generator.
4
|
