 |
|||
|
|
|||
|
Page Title:
TABLE 3-2. INTERMEDIATE INSPECTION REQUIREMENTS |
|
||
| ||||||||||
|
|
 TM 55-4920-373-14&P
TABLE 3-1. DAILY INSPECTION REQUIREMENT (cont)
REQUIREMENTS
DAILY INSPECTION
ITEM
Start and operate test stand and
Postinspect
8. Test stand
check for high pressure hydrau-
lic leaks, Check that maximum
hydraulic pressure (3000 psi) is
obtainable at maximum G. P. M.
Check temperature and flow
indications. (Refer to chapter
TABLE 3-2. INTERMEDIATE INSPECTION REQUIREMENTS
INTERMEDIATE
REQUIREMENT
INSPECTION
ITEM
APPEARANCE. Inspect the
50 hrs
General
general appearance of the
equipment, paying particular
attention to cleanliness.
BEFORE-OPERATION SER-
VICES. Perform the services
listed in daily before-operation
services (table 3-1)
50 hrs
LUBRICATION. Inspect for
Lubrication fittings
missing or damaged lubrication
fittings and inspect for indica-
tions of improper lubrication.
Lubricate as necessary in
accordance with the lubrication
chart. Replace missing or
damaged fittings. Correct all
oil or grease leaks
50 hrs
Inspect lubricant level in engine
crankcase. Inspect for oil and
grease leaks.
Inspect for leaks, loose mount-
Manifold
50 hrs
ing and defective gaskets.
Tighten loose mounting bolts
and nuts. During the first
weekly servicing of a new or
reconditioned engine, inspect
all head bolts for tightness.
Let engine warm up to normal
operating temperature and
tighten all loose bolts from 25
to 32 ft. lbs. torque
50 hrs
Inspect for leaks, loose mount-
ing and defective gaskets.
Tighten loose mounting bolts
and nuts. During the first
weekly servicing of a new or
reconditioned engine, inspect
all head bolts for tightness. Let
engine warm up to normal oper-
ating temperature and tighten
3-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals