|
| |
TM 1-1730-231-13&P
3-31. HYDRAULIC PIPING
3-31
This task covers:
A. INSPECTION
B. REPAIR (AVIM)
C. REMOVAL
D. INSTALLATION
E. TEST (AVIM)
INITIAL SETUP
Tools
Tool Kit, Hydraulic, NSN 5180-00-323-4891
Shop Set, AVIM, Hydraulic, NSN 4920-00-165-1454
Personnel Required
MOS 67 and MOS 68H
General Safety Instructions
WARNING
Be sure that all electrical power is removed from
the unit before beginning any maintenance
operation.
To avoid personnel injury, the pump must be
shut down before beginning any maintenance
operation.
NOTE
Tag all disconnected tubing and lines to ease
reinstallation.
A.
INSPECTION
Check all hydraulic lines, tubing, fittings, and manifold for damage, loose connections, and leakage.
B.
REPAIR (AVIM)
1.
Repair or replace all damaged or worn lines, tubing, fittings, and manifold.
2.
Tighten all loose connections.
C.
REMOVAL
Disconnect and remove hydraulic lines, tubing, fittings, and manifold only to the extent necessary for the repair or
replacement of damaged or worn parts.
GO TO NEXT PAGE
3-45
|
