Inspection of Used Equipment.

SECTION I (Con't.)

2 flat washers, and 2 lockwashers, and 2 hex nuts.

(b) Clean all corrosion from the battery terminal

adapters and terminals.

Apply a thin film of

grease to the terminals end adapters and connect

the cables to the battery.

(E) Tires.

Check the tire inflation.

Correct tire pressure

iS 60 PSI.

(F) Hydraulic System.

(1) Drain the preservative fluid from the system by removing

the drain plug from the bottom of the low pressure filter.

(2) Install the drain plug.

Remove the reservoir fill cap

and fill the reservoir with 20 gallons of hydraulic

fluid, Specification MIL-0-5606.

Do not overfill the hydraulic reservoir.

NOTE .

The expansion space in the reservoir is necessary

for satisfactory test stand operation.

(3) Bleed air from the hydraulic system as described in

Section 2-26.

1-10. Inspection of Used Equipment.

Inspect a used test stand, following the instructions contained in

Section 2-8. Observe carefully the component parts that might be worn

through use, such as connecting hose assemblies, tires, brakes, and

drawbar assembly.

Correct all deficiencies or report them to field

maintenance.

1-11. Servicing Used Equipment.

Service a used test stand as outlined in Section 1-9. Pay particular

attention to the air cleaner, oil filter, fuel strainer, battery and

Report all deficiencies, found during servicing, to field

tires l

maintenance for correction.

-15-