Battery.

SECTION I (Con't.)

and stud to one side and remove the glass bowl,

gasket, and filter screen from the bowl cover.

(c) Wash the bowl and screen in an approved cleaning

solvent and wipe the bowl dry with a lint-free

cloth.

(d) Install the sceen, gasket, and bowl in the

cover and scoure with the clamp wire and the

thumbnut.

(e) Open tie shutoff cock and cheek the fuel strainer

for leaks.

(D) Battery.

(1) The battery of a new test stand is shipped

(1)

dry charged and must be filled with electrolyte before

use. Fill each cell to the level indicator or 3/8 inch

over the plates.

WARNING: Battery electrolyte contains sulfuric acid

and can cause severe skin burns. If the electrolyte

comes in contact with the body, clothing or painted

surfaces, rinse immediately with clean water.

Removal.

(2)

(a) Disconnect the two battery terminal adapters from

the terminals of the battery.

(b) Remove the 2 hex nuts, 2 lockwashers, and 2 flat

washers that secure the cover assembly and battery

to the battery tray and remove the battery.

Installation.

(3)

(a) Place the battery in the battery tray, mount the

cover assembly on the battery and secure with the