 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 55-4920-442-13 & P
3-41. Brake assembly - Replace (cont.)
3-41
END OF TASK
INSTALLATION
1.
Position the brake assembly on the rear axle and aline holes.
2.
Install four hex head cap screws through the brake assembly and place a lock washer and a plain hex nut on each
screw. Tighten nuts to a torque of 19 ft-lbs.
3.
Position the brake drum and hub assembly on brake assembly after installing hub and bearings (refer to illustration
above).
NOTE
Brake assembly is self adjusting.
GO TO NEXT PAGE
3-54
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals