|
| |
TM 9-5130-338-12&P
4-13. REVERSING SPOOL AND PREFORMED PACKING REPLACEMENT-Continued.
c.
Installation.
CAUTION
Sliding reversing spool (2) through main housing (7) after installation of preformed packings (5
and 6) will cause damage to preformed packings.
1.
Apply a small amount of lubricating oil to two new preformed packings (5 and 6).
NOTE
Ensure backup ring (3) is to side toward end of reversing spool.
2.
Install new preformed packing (5) and new backup ring (3) on snapring end of reversing spool (2).
3.
Slide reversing spool (2) from right side just far enough to allow installation of preformed packing (5) and
backup ring (3) in groove.
4.
Install reversing spool (2) into right side of main housing (7) until lever end of reversing spool extends
through main housing.
5.
Install new preformed packing (6) and new backup ring (4) on lever end of reversing spool (2).
6.
Slide reversing spool (2) from left side until left end of revering spool extends from right side of main
housing (7).
7.
Install new snapring (1) on reversing spool (2).
NOTE
Follow-on maintenance: Install lever
on reversing spool (see para. 4-12).
4-12
|
