SECTION I (Con't.)
(B) Make a complete visual inspection of' the test stand for
dents, cracks, breaks, and loose or missing parts.
sure all components are securely mounted.
(C) Inspect control panels for cracked or broken glass and
(D) Inspect the tires for cuts, fabric breaks, and excessively
(E) Correct all deficiencies or report them to organizational
1-9 Servicing New Equipment.
(A) General. Perform the before -operation services as described
Lubricate the test stand in accordanoe with
the lubrication chart table I.
(C) Fuel System.
(1) Filling Fuel Tank. Remove the fuel tank cap and fill
the fuel tank to capacity with the proper grade fuel,
specification MIL-G-3056 or MIL-F-5572. Use a clean
WARNING: Always provide a metal-to-metal contaot
between the container and fuel tank when filling the
tank with fuel. This will prevent a spark from being
generated as gasoline flows over the metal surfaces.
(2) Fuel Strainer.
(a) Close the shutoff cock of the fuel strainer by
turning its handle fully clockwise.
(b) Loosen the thumbnut and cup, swing the clamp wire