TM 5-2350-378-23&P
0018
VEHICLE DOES NOT RESPOND TO OPERATOR CONTROLS - Continued
c.
Disable ejector by manually closing ejector inhibit ball valve V23 (Figure 8, Item 1) on DCV bank.
d.
Using LINE UP or LINE DOWN button (Figure 9, Item 3), select V1 on HDC display (Figure 9, Item 2).
e.
Close V1 on HDC display (Figure 9, Item 2) by selecting CHANGE POSITION button (Figure 9, Item 4)
on HDC control box.
f.
Have assistant start engine, move SPRUNG/UNSPRUNG lever to SPRUNG and move EJECTOR
CONTROL lever to BACK.
g.
Read transducer T-3 hydraulic pressure on HDC display (Figure 9, Item 1).
h.
While holding EJECTOR CONTROL lever to BACK, have assistant move right-hand SUSPENSION
CONTROL lever to RAISE.
i.
Read transducer T-3 hydraulic pressure on HDC display (Figure 8, Item 1).
j.
Stop engine; relieve hydraulic pressure.
k.
Enable ejector by manually opening ejector inhibit ball valve V23 (Figure 8, Item 1) on DCV bank.
1
T01610HDC
Figure 8. Directional Control Valve (DCV) Bank.
l.
Using LINE UP or LINE DOWN button (Figure 9, Item 3), select V1 on HDC display (Figure 9, Item 2).
m.
Open V1 on HDC display (Figure 9, Item 2) by selecting CHANGE POSITION button (Figure 9, Item 4)
on HDC control box.