TM 5-2350-378-23&P
0020
WINCH WILL NOT PULL RATED LOAD - Continued
c.
Pull shift rod (Figure 10, Item 3) out as far as possible.
d.
This is the end of travel in high-gear position.
e.
Push shift rod (Figure 10, Item 3) back in 1.220 in. (30.99 mm) to locate center of NEUTRAL position.
f.
Adjustment can be made by turning clevis (Figure 10, Item 2) clockwise for NEUTRAL position out;
counterclockwise for NEUTRAL position in.
g.
Install clevis (Figure 10, Item 2) on control lever (Figure 10, Item 5) with clevis pin (Figure 10, Item 1)
and new cotter pin (Figure 10, Item 4).
h.
Verify shift rod (Figure 10, Item 3) is within NEUTRAL travel limits.
1
3
2
5
4
T01815HDC
Figure 10. Winch Linkage.
i.
Operate winch and check for proper operation.
j.
If winch does not function properly, notify supervisor.
CONDITION/INDICATION
Can linkage be adjusted?
DECISION
YES - Verify problem is solved.
NO - Replace winch (TM 5-2350-262-20).
END OF WORK PACKAGE
0020-11/12 blank
03/15/2011Rel(1.8)root(tswp)wpno(T00018)