TM 5-2350-378-23&P
0037
INSTALLATION
WARNING
Do not work under vehicle unless hull is on jack stands and apron lockpins are installed.
Failure to comply may result in severe injury or death to personnel.
NOTE
Installation steps are accomplished through access under vehicle.
After installation is complete, remove tags from all hydraulic lines and wiring harness
leads.
1.
Install right forward manifold (Figure 4, Item 3) using two flat washers (Figure 4, Item 4) and two new machine
bolts (Figure 4, Item 5).
2.
Connect wiring harness W3 connector P11 (Figure 4, Item 9) to transducer T11 (Figure 4, Item 8) on right
forward manifold (Figure 4, Item 3).
3.
Connect wiring harness W3 connectors P2 and P10 (Figure 4, Item 7) to two two-way (NO) valves V2 and V10
(Figure 4, Item 6) on right forward manifold (Figure 4, Item 3).
4.
Remove all caps and plugs from hydraulic fittings.
5.
Connect five hydraulic hoses (Figure 4, Item 1) and three hydraulic tubes (Figure 4, Item 2) to right forward
manifold (Figure 4, Item 3).
0037-6
03/15/2011Rel(1.8)root(maintwp)wpno(M00009)