TM 5-2350-378-23&P
0032
REMOVAL
WARNING
Ensure that vehicle power is off and battery disconnected. Remove all jewelry, such as rings,
dog tags, bracelets, etc. If jewelry or disconnected battery ground cable contacts battery
positive terminal, a direct short will result, causing instant heating of tools, tool damage,
battery damage, or battery explosion. Failure to comply may result in severe injury or death.
1.
Remove dust cap (Figure 1, Item 5), four screws (Figure 1, Item 4), nutplate (Figure 1, Item 1), and wiring
harness W3 connector J1 (Figure 1, Item 2) from Hydraulic Diagnostic Center (HDC) disconnect bracket
(Figure 1, Item 3).
2.
Remove wiring harness W3 connector P5 (Figure 1, Item 7) from transducer T5 (Figure 1, Item 6) at forward
right actuator #1 (Figure 1, Item 8).
3.
Remove wiring harness W3 connector P31 (Figure 1, Item 10) from transducer T6 (Figure 1, Item 11) at forward
left actuator #1 (Figure 1, Item 9).
0032-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00007)