TM 5-2350-378-23&P
0032
INSTALLATION
WARNING
Ensure that vehicle power is off and battery disconnected. Remove all jewelry, such as rings,
dog tags, bracelets, etc. If jewelry or disconnected battery ground cable contacts battery
positive terminal, a direct short will result, causing instant heating of tools, tool damage,
battery damage, or battery explosion. Failure to comply may result in severe injury or death.
1.
Position wiring harness W3 in vehicle, secure in cable clamps, and secure with new tie down straps.
2.
Connect wiring harness W3 connector P33 (Figure 4, Item 6) to transducer T8 (Figure 4, Item 5) at right sprung
stop cylinder (Figure 4, Item 4).
3.
Connect wiring harness W3 connector P32 (Figure 4, Item 3) to transducer T9 (Figure 4, Item 2) at left sprung
stop cylinder (Figure 4, Item 1).
1
2
3
4
5
6
LEFT ACTUATOR
ACCESS AREA
RIGHT ACTUATOR
ACCESS AREA
M0021HDC
Figure 4. Wiring Harness W3 at Actuator Area Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00007)