TM 5-2350-378-23&P
0036
WARNING
High oil pressure is present in the M9 ACE hydraulic system. Do not disconnect any
hydraulic system component unless hydraulic system pressure has been relieved. After
hydraulic system has been relieved, wait at least four minutes before disconnecting any
hose or fitting. Ensure each of the hydraulic control levers is moved several times through
all positions and the hydraulic tank dipstick is slowly loosened to relieve pressure. Failure
to comply may result in severe injury or death to personnel.
Do not work under vehicle unless hull is on jack stands and apron lockpins are installed.
Failure to comply may result in severe injury or death to personnel.
NOTE
All removal steps are accomplished through access under vehicle.
Tag all hydraulic lines and wiring harness leads being disconnected to assist in
installation.
REMOVAL
1.
Remove wiring harness W3 connectors P3 and P9 (Figure 1, Item 6) from two two-way (NO) valves V3 and
V9 (Figure 1, Item 5) on left forward manifold (Figure 1, Item 9).
2.
Remove wiring harness W3 connector P30 (Figure 1, Item 3) from transducer T10 (Figure 1, Item 4) on left
forward manifold (Figure 1, Item 9).
CAUTION
Cap or plug all oil ports and ends of hoses and tubes when oil hoses or tubes are disconnected
or removed to prevent contamination. Failure to comply may result in damage to equipment.
3.
Remove five hydraulic hoses (Figure 1, Item 2) and three hydraulic tubes (Figure 1, Item 1) from left forward
manifold (Figure 1, Item 9).
4.
Remove two machine bolts (Figure 1, Item 7), two flat washers (Figure 1, Item 8), and left forward manifold
(Figure 1, Item 9) from vehicle. Discard machine bolts.
0036-2
03/15/2011Rel(1.8)root(maintwp)wpno(M00008)
