TM 5-2350-378-23&P
0036
INSTALLATION
WARNING
Do not work under vehicle unless hull is on jack stands and apron lockpins are installed.
Failure to comply may result in severe injury or death to personnel.
NOTE
Installation steps are accomplished through access under vehicle.
After installation is complete, remove tags from all hydraulic lines and wiring harness
leads.
1.
Install left forward manifold (Figure 4, Item 9) using two flat washers (Figure 4, Item 8) and two new machine
bolts (Figure 4, Item 7).
2.
Connect wiring harness W3 connector P30 (Figure 4, Item 3) to transducer T10 (Figure 4, Item 4) on left forward
manifold (Figure 4, Item 9).
3.
Connect wiring harness W3 connectors P3 and P9 (Figure 4, Item 6) to two two-way (NO) valves V3 and V9
(Figure 4, Item 5) on left forward manifold (Figure 4, Item 9).
4.
Remove all caps and plugs from hydraulic fittings.
5.
Connect five hydraulic hoses (Figure 4, Item 2) and three hydraulic tubes (Figure 4, Item 1) to left forward
manifold (Figure 4, Item 9).
0036-6
03/15/2011Rel(1.8)root(maintwp)wpno(M00008)