TM 5-2350-378-23&P
0027
REMOVAL
WARNING
Ensure that vehicle power is off and battery disconnected. Remove all jewelry, such as rings,
dog tags, bracelets, etc. If jewelry or disconnected battery ground cable contacts battery
positive terminal, a direct short will result, causing instant heating of tools, tool damage,
battery damage, or battery explosion. Failure to comply may result in severe injury or death.
1.
Remove dust caps (Figure 1, Item 14) from wiring harness connectors W1J1 (Figure 1, Item 18), W2J1
(Figure 1, Item 19), and W3J1 (Figure 1, Item 4).
2.
Remove four screws (Figure 1, Item 16), nutplate (Figure 1, Item 1), and wiring harness connector W1J1
(Figure 1, Item 18) from disconnect bracket (Figure 1, Item 17).
3.
Remove four screws (Figure 1, Item 15), nutplate (Figure 1, Item 2), and wiring harness connector W2J1
(Figure 1, Item 19) from disconnect bracket (Figure 1, Item 17).
4.
Remove four screws (Figure 1, Item 13), nutplate (Figure 1, Item 3), and wiring harness connector W3J1
(Figure 1, Item 4) from disconnect bracket (Figure 1, Item 17).
5.
Disconnect circuit 10 (Figure 1, Item 8) and circuit 1070 (Figure 1, Item 5) connectors from Hydraulic Diagnostic
Center (HDC) circuit breaker (Figure 1, Item 11).
6.
Remove two nuts (Figure 1, Item 9), two lockwashers (Figure 1, Item 10), two screws (Figure 1, Item 12), and
HDC circuit breaker (Figure 1, Item 11) from HDC disconnect bracket (Figure 1, Item 17). Discard lockwashers.
7.
Remove two machine bolts (Figure 1, Item 6), two flat washers (Figure 1, Item 7), and disconnect bracket
(Figure 1, Item 17) from bulkhead. Discard machine bolts.
8
9
10
11
5
3
6
2
12
4
1
7
19
13
18
17
15
14
14
16
14
M0004HDC
Figure 1. Hydraulic Diagnostic Center (HDC) Disconnect Bracket Removal.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00003)