TM 5-2350-378-23&P
FIELD MAINTENANCE
TROUBLESHOOTING PROCEDURES - EJECTOR CREEPS
INITIAL SETUP:
Tools and Special Tools
References
Tool Kit, General Mechanic's: Automotive
Equipment Condition
Vehicle MASTER power OFF (TM 5-2350-262-10)
Personnel Required
Construction Equipment Repairer, 91L (Two)
Vehicle on jack stands (TM 5-2350-262-20)
TROUBLESHOOTING PROCEDURE
WARNING
High oil pressure is present in the M9 ACE hydraulic system. Do not disconnect any
hydraulic system component unless hydraulic system pressure has been relieved. After
hydraulic system has been relieved, wait at least four minutes before disconnecting any
hose or fitting. Ensure each of the hydraulic control levers is moved several times through
all positions and the hydraulic tank dipstick is slowly loosened to relieve pressure. Failure
to comply may result in severe injury or death to personnel.
Transmission shifting lines are pressurized. Do not disconnect lines, fittings, or
accumulator unless transmission shift control valve pressure has been relieved.
Discharge transmission shift accumulator by moving shift control lever through all forward
and reverse ranges several times, with engine off. Failure to comply may result in severe
injury to personnel.
NOTE
Hydraulic oil is supplied to the ejector cylinder through circuits 21 and 22. When actuated,
the ejector control valve distributes hydraulic pressure to extend the ejector cylinder through
port 21 and retract the ejector cylinder through port 22. Hydraulic pressure is controlled by
the ejector relief valve 21 on DCV control bank.
0010-1
03/15/2011Rel(1.8)root(tswp)wpno(T00008)